Sep 24, 2011 · I think cutting the filet off at the ribs waste a lot of precious meat and perch filets are pretty small already. You need a good (very sharp!) fileting knife to do all this. If done properly, you …

Apr 7, 2013 · Whenever I have a problem getting the grease gun off a zerk I put a standard screwdriver tip in between the base the zerk is screwed into and the grease gun fitting and give a twist. The …

Jun 28, 2018 · Ok so my trollin motor Arrow points one way and boat goes in different direction when engaged..driving me nuts..any simple fixes out there?

Jun 29, 2009 · Id you unhook your battery, wait a couple minutes, and rehook the battery, the computer should reboot back to normal operation. My dealer said you can sometimes effect this same thing by …

Jan 19, 2015 · For your stern lines, I would come off of the rings on the back of your boat that you use to secure it to the trailer. Get some stainless clips to attach to your dock lines so you can just clip them …

Oct 18, 2017 · Not sure where my problem is at this point. Last time out my live well pump stayed on. I ended up pulling the line off the fuse block. Got a new switch but same issue. On -off-on switch …

Aug 27, 2019 · I attach 2 small bungees to lid & barrel so it can't blow off. 3- 5" od toilet floor flanges cut & bolted into each bottom, with a 'short' 90* elbow & 5" of pvc. Sometimes, a small 1/4" x 1' piece of …

Jan 3, 2008 · It is a trade-off for the nice finish. - Bumps, With the devcon the window is tighter than envirotech. I have had devcon start to set on me if I get too picky with the finish as I am brushing it …

Oct 2, 2014 · Run a VERY sharp knife and scrape the skin all around where the filet would come off of. After your knife fills with goop, clean it off and repeat until you remove ALL of the slime.

Oct 22, 2007 · I Have A 'o1 Merc 115 Hp. I Take Pride In Keeping My Boat Clean. But I Can Not Find Anything To Remove Water Spots On Motor. I Even Tried To Use Rubbing Compound. Any …